Bullitt Pedals

It's been a while since I spent any money on her. So I went ahead and did it....Pulled the trigeer on these yesterday . Hope to get them tomorrow and install them...

Can't wait

Be careful with those. If they have tabs that hold onto the pedal they can slip off and pinch the pedal to the floor or not allow you to stop. If they do have tabs. take them off. Go to the hardware store, and get yourself some countersunk flat head bolts. Remove the rubber from the stock pedal. Drill a hole through the existing mounting bolt holes in the new pedal covers. and lock washer them on.

Ok, Sounds good. I will do that if they have the tab. At least you responded to this. It seems like no one is getting on this forum.

Pretty sure those are the ones without tabs...they have hard ass rubber that holds em on. You have to boil em to get the rubber soft enough to go around the stock pedals.

"..insert rubber comments here.."

yeah, I have the ones with the hard rubber you have to boil to get them on, not sure where my boyfriend bought them from though.

They were suppose to get rid of the tabs for the 04 cobras. Due to the fact that Ford had a recall on all 03 cobras for that reason. Fords fix was attaching a metal plate over the carpet. I know this because that was the first thing I had done when I purchased my 03 Cobra. I researched all TSBs and recall on the car.

Well I forgot to put the picture up of the pedals...they are a bit dirty.

Better late than never!

Looks good, Juan

Looks good! Glad to see your love affair with the car started up again!