50 throttle body

What do you guys/gals think of Professional Products throttle bodies? I was checking them out on UPR's website and I've been searching for a 65mm or 70mm throttle body.

I've seen them where the iac bolts are way off and they cause vacuum leaks or the iac just won't bolt up. But then again that might just be a few rare cases. For mild fox stick with a 65mm btw. A 65mm flows enough air to support a pretty healthy 5.0.

I would not by anything from PP, just my .02

Aaron, I have one, no issues.

PRO50SC wrote:Aaron, I have one, no issues.

Don't you have their intake manifold too? I still have my stock one.

Yup, and the egr spacer. No problems w/ any of them. The casting on the intake is a lil rough and may require some clean up, but the other 2 pieces, no problems.

I run a professional products tb and spacer as well. The iac bolts were drilled so the idle plate didn't line up right. I just drilled and tapped new holes.

I don't know about their pushrod stuff, but for modular's they are crap!!!

When I purchase something, I don't want to have to clean this up or drill this out!